Kesälahja sinulle

Tarjoamme TEKNOsim 6 -ohjelman käyttöösi maksutta loppuvuodeksi. Lataa elokuun loppuun mennessä ja käytä vuoden loppuun. TEKNOsim on nopein sisäilmaolosuhteiden simulointiohjelma, joka laskee ketterästi jäähdytys- ja lämmitystarpeet rakennuksille.

Tutustu TEKNOsimiin
Siirry pääsisältöön

PutkikäyräBK

Pipe bends in 45, 70 or 85 degrees have been developed to fit gutter outlets perfectly. There is no need for fasteners or rivets to prevent the bend from falling down.

The bend is conical with one large and one small end, with the exception of 50 mm at each end, which is straight for a perfect fit to both the gutter outlet and the downpipe.

The end with the label is always the small end that fits into the next product in the system. All products in the round downpipe range have this logic to make installation easier and quicker. The label is concealed after installation.

This bend is made of powder-coated galvanised steel with 0.6 mm thickness. The powder has been carefully developed to match perfectly with the pre-coated material and there is no difference in design.

OminaisuusArvo